Skip to main content

Mark Top and Bottom Stringer Cuts — Mark the Nosing and Final Cut

Beginner4 hours

Part of project

How to Lay Out a Stair Stringer with a Framing Square · Step 5 of 6

Helpful?

In this video

To complete the top of the stringer, turn the framing square 90 degrees and align the blade with the last marked tread line. Make sure it's perfectly lined up, then draw a horizontal line to finish off the top of the stringer. For the bottom of the stringer, line up the tongue of the framing square with the bottom marked tread, ensuring perfect alignment with the pencil mark and in the corner. Then measure and mark out the riser distance (7 and 5/16 inches in this case). This adjustment needs to be applied if your stringer is going to be attached to a subfloor first, and then finished flooring will be added on top. You need to drop the stringer by the thickness of the tread minus the thickness of the finished floor. For example, if your tread thickness is 1.5 inches, you need to remove that amount from the bottom of the stringer so that once the finished tread is added, your rise remains consistent.

3.6M views41.5K
stairbuilding

75K subscribers

View Channel

FAQs

What is the most critical tool for ensuring accurate stair stringer layout?

The framing square, especially when used with stair gauges, is indispensable for consistently marking the rise and run on the stringer. A construction calculator is also highly recommended to minimize mathematical errors and ensure precise measurements.

How important is accuracy when marking a stair stringer, and what are the safety implications?

Accuracy is paramount for safety; even small errors can lead to uneven steps, creating a significant tripping hazard. Double-check all measurements and markings before cutting, as consistent riser heights and tread depths are crucial to prevent falls.

Can I use different materials for stair stringers, or is pressure-treated pine always necessary?

While pressure-treated pine is excellent for outdoor use or areas prone to moisture, untreated lumber like Douglas fir or Southern Yellow Pine can be used for indoor stairs. Always select straight, knot-free lumber of appropriate dimensions that meets local building codes for structural integrity.

What's a common mistake beginners make when laying out stringers, and how can I avoid it?

A frequent error is forgetting to account for the thickness of the treads and the necessary bottom cut for the finished floor. Ensure you deduct the tread thickness from the bottom riser and factor in the nosing overhang for consistent steps from top to bottom.

Transcript
Hide

stop at this point you'll need the turn  90 degrees to finish off the top of the   stringer to do that remove the square from the  clamps and line up the blade with the tread line   making sure it's lined up perfectly draw the  90 degree line now it's time to move back down   to the bottom and draw the last riser line up the  tongue with the tread making sure you're perfectly   in line with the pencil mark and in the corner  here and then measure and mark out the riser   distance again in this case that's seven and  five sixteenths then turn the square 90 degrees   and mark out where the stringer will contact the  floor the next step before we actually cut the   stringer is that we need to drop the stringer  the thickness of the tread now what this does   is it makes the unit rises equal throughout for  example the tread thickness of our mock-up is   an inch and a half or 38 mil therefore we need to  remove that amount from the bottom of the stringer   that way once the tread is added our rise still  remains 7 and 5 16 on the first and last steps   however if you have a finished floor going down  you need to drop the stringer the thickness of the   tread minus the thickness of the finished floor  again this only applies if your stringer is going   to get attached to the sub floor first and then a  finished floor is going to be added on top of that  

Auto-generated transcript. May contain errors.