Skip to main content

Mark the Stair Stringer for Cutting — Mark the Stair Stringer with a Framing Square

Beginner4 hours

Part of project

How to Lay Out a Stair Stringer with a Framing Square · Step 4 of 6

Helpful?

In this video

Now that the individual rise (7.5 inches) and run (9.25 inches) are determined, use a framing square to mark the pattern on a 2x12 board. The framing square has markings to quickly set these dimensions. Hold the square with the rise measurement (7.5 inches) on one edge of the 2x12 and the run measurement (9.25 inches) on the other. Use a pencil to draw the lines. Repeat this process for each step, sliding the square down the board. For the first step (which connects to the ground/pad), ensure that the bottom rise is reduced by the thickness of the finished tread material. The video shows marking three steps on the stringer.

98.7K views2.2K
stairbuilding

75K subscribers

View Channel

FAQs

What is the most critical tool for ensuring accurate stair stringer layout?

The framing square, especially when used with stair gauges, is indispensable for consistently marking the rise and run on the stringer. A construction calculator is also highly recommended to minimize mathematical errors and ensure precise measurements.

How important is accuracy when marking a stair stringer, and what are the safety implications?

Accuracy is paramount for safety; even small errors can lead to uneven steps, creating a significant tripping hazard. Double-check all measurements and markings before cutting, as consistent riser heights and tread depths are crucial to prevent falls.

Can I use different materials for stair stringers, or is pressure-treated pine always necessary?

While pressure-treated pine is excellent for outdoor use or areas prone to moisture, untreated lumber like Douglas fir or Southern Yellow Pine can be used for indoor stairs. Always select straight, knot-free lumber of appropriate dimensions that meets local building codes for structural integrity.

What's a common mistake beginners make when laying out stringers, and how can I avoid it?

A frequent error is forgetting to account for the thickness of the treads and the necessary bottom cut for the finished floor. Ensure you deduct the tread thickness from the bottom riser and factor in the nosing overhang for consistent steps from top to bottom.

Transcript
Hide

i hope this all makes sense so now that you have your rise measurement and your run measurement you can grab your frame and square and go over to your two by 12. so i've determined that my rise is seven and a half and my run is nine and a quarter so i want to take my frame and square and this is going to be my rise side so you can see the numbers here one two three all the way to seven and a half i want to hold my finger right there and then on the run side i'm gonna go to nine and a quarter which is right here i'm gonna put my finger right there and you line it up on your two by twelve you can actually buy these little brass nuts that go right here that makes this easier if you have a lot more steps or if you're going to be doing this a lot but i don't need them put that at nine and a quarter put this one at seven and a half and i'm gonna mark that now i'm going to take the square and i'm just going to move it down right to that point and hold it seven and a half and then hold this one over here at nine and a quarter and mark that and this is a small stringer if you had a longer one you just keep doing that same thing all the way down but with me that's as many as i need so i'm going to hold this square right like this along this line and make a mark right here so this is my top riser this will be my first run or my first step so i want to measure this at nine and a quarter and then i want to hold my square again square against this line and right at that mark and mark that so this is the top of the stringer first run first rise second run last rise and as i said before we're going to take off the material whatever the thickness of the material is from the bottom so you can measure from that line you made here whatever your material is and then move your square down hold it on that line and mark that now that is the bottom of the stringer and i can cut this out

Auto-generated transcript. May contain errors.