Skip to main content

Lay Out the Stringer Using a Framing Square — Mark the Stair Stringer with a Framing Square

Beginner4 hours

Part of project

How to Lay Out a Stair Stringer with a Framing Square · Step 4 of 6

Helpful?

In this video

Select a straight 2x12 piece of lumber for the stringer. Gather a framing square, a straight piece of wood (or square fence), and clamps. Attach the straight piece of wood to the framing square using clamps to set your unit run and unit rise measurements. For example, line up the 10-inch mark on the blade (unit run) with the edge of the wood, and the 7 and 5/16-inch mark on the tongue (unit rise) with the edge of the wood, then clamp. Perform a test mark on the stringer board to confirm accurate setup. If marks are incorrect, make adjustments to the square and clamps. Continue this process, sliding the square along the lumber to mark out each tread and riser. Stop marking once you've marked the last full tread.

3.6M views41.5K
stairbuilding

75K subscribers

View Channel

FAQs

What is the most critical tool for ensuring accurate stair stringer layout?

The framing square, especially when used with stair gauges, is indispensable for consistently marking the rise and run on the stringer. A construction calculator is also highly recommended to minimize mathematical errors and ensure precise measurements.

How important is accuracy when marking a stair stringer, and what are the safety implications?

Accuracy is paramount for safety; even small errors can lead to uneven steps, creating a significant tripping hazard. Double-check all measurements and markings before cutting, as consistent riser heights and tread depths are crucial to prevent falls.

Can I use different materials for stair stringers, or is pressure-treated pine always necessary?

While pressure-treated pine is excellent for outdoor use or areas prone to moisture, untreated lumber like Douglas fir or Southern Yellow Pine can be used for indoor stairs. Always select straight, knot-free lumber of appropriate dimensions that meets local building codes for structural integrity.

What's a common mistake beginners make when laying out stringers, and how can I avoid it?

A frequent error is forgetting to account for the thickness of the treads and the necessary bottom cut for the finished floor. Ensure you deduct the tread thickness from the bottom riser and factor in the nosing overhang for consistent steps from top to bottom.

Transcript
Hide

to lay out for our first stringer the first step  is to find a really nice straight piece of lumber   in this case i'm using a 2 by 12. next grab a  framing square a straight piece of wood and a few   clamps using the blade of the square line up the  10 which is our unit run with the edge of the wood   and clamp it in place then using the tongue of the  square line up the 7 and 5 16 which is our rise   with the edge of the wood and clamp that in  place i like to do a test mark to make sure   i'm set up in the correct position so i use  the back of the lumber and draw both lines   once that's done i double check my marks with a  tape measure to ensure that i have exactly what   i'm intending for some reason if you don't simply  make some adjustments to the square and clamps   now slide the square down leaving enough room to  fit one riser in before the end of the material   with the square held firmly into position mark out  for one tread and one riser then slide the square   up carefully lining up the 10 mark with the  7 and 5 16 and make another set of lines   so far we have two treads and three risers one two  and a third one which we haven't yet marked out   again we need to cut a total of four risers and  four treads continue marking another two times   but once you've marked out for the last tread stop at this point you'll need the turn  90 degrees to finish off the top of the  

Auto-generated transcript. May contain errors.