Skip to main content

Flush Irrigation Lines — Flush the System

Beginner4 hours

Part of project

Irrigation System Repair · Step 9 of 10

Helpful?

In this video

Before attaching the new sprinkler head, it is crucial to flush the irrigation lines. Turn on the main water supply for the irrigation system (if it was turned off) and then activate the specific zone controlling the repaired pipe. Allow water to flow freely from the cut end of the pipe for a few seconds. This action will push out any dirt, rocks, or other debris that might have entered the line during the repair process, preventing future clogs in the new sprinkler head.

38.4K views443
The Handyman

532K subscribers

View Channel

FAQs

What specialized tools are essential for irrigation system repair beyond general household tools?

You'll definitely need a good shovel for digging, especially around pipes without damaging them. A hook and pick set is invaluable for cleaning stubborn sprinkler nozzles, and an adjustable wrench will help with various fittings. Don't forget PVC primer and cement for pipe repairs, and Teflon tape for threaded connections.

My sprinkler zone isn't turning on at all. Where should I start troubleshooting?

First, verify the zone is programmed correctly on your controller and that the master valve (if you have one) is open. Then, locate the valve for the non-working zone. Manually turn the solenoid a quarter turn counter-clockwise or flip its lever to see if the sprinklers activate, which helps isolate if the issue is electrical or mechanical within the valve itself.

How can I pinpoint an underground leak without excavating my entire lawn?

Look for unusually wet or overly green spots in your yard, or areas where the grass is unusually lush. You can also listen for hissing sounds near the main line or check your water meter for continuous movement even when all water sources are off, indicating a constant flow.

What are the most important safety precautions to take when digging for underground irrigation repairs?

Always call 811 (or your local 'dig safe' number) a few days before you dig to have underground utility lines marked. Wear sturdy gloves to protect your hands from debris and tools. Dig carefully and by hand when you get close to pipes or marked lines to avoid damaging them or other utilities.

Transcript
Hide

head cuz it just clogs it up and makes it where it doesn't work very well so let me go rinse this off and I'll be right back a great practice any time that you have to replace a sprinkler head is to flush your lines after you've got your pipe cut off uh you you can put some kind of system in there to catch water turn on your irrigation line let it spray out any dirt or rocks that may have gotten in the lines you want to check your fittings for cracks um this is actually a new one that I had I'll

Auto-generated transcript. May contain errors.