Skip to main content

Flush the Irrigation System — Flush the System

Beginner4 hours

Part of project

Irrigation System Repair · Step 9 of 10

Helpful?

In this video

After any repair, it's crucial to flush the irrigation system to remove any dirt or debris that may have entered during the repair process. Failure to do so can lead to clogged drip emitters. To flush the system, locate the end of the drip line and remove its end cap or end piece. Place a rock or another small object underneath the open end of the hose to keep it elevated off the ground; this prevents water from flowing back in and pulling in dirt and debris once the water is turned off. Turn on the water supply and let it run for 30 to 40 seconds until the water running out of the end appears clear. Once flushed, turn off the water, remove the rock, and reattach the end cap or end piece securely.

173.2K views3.2K
The Handyman

532K subscribers

View Channel

FAQs

What specialized tools are essential for irrigation system repair beyond general household tools?

You'll definitely need a good shovel for digging, especially around pipes without damaging them. A hook and pick set is invaluable for cleaning stubborn sprinkler nozzles, and an adjustable wrench will help with various fittings. Don't forget PVC primer and cement for pipe repairs, and Teflon tape for threaded connections.

My sprinkler zone isn't turning on at all. Where should I start troubleshooting?

First, verify the zone is programmed correctly on your controller and that the master valve (if you have one) is open. Then, locate the valve for the non-working zone. Manually turn the solenoid a quarter turn counter-clockwise or flip its lever to see if the sprinklers activate, which helps isolate if the issue is electrical or mechanical within the valve itself.

How can I pinpoint an underground leak without excavating my entire lawn?

Look for unusually wet or overly green spots in your yard, or areas where the grass is unusually lush. You can also listen for hissing sounds near the main line or check your water meter for continuous movement even when all water sources are off, indicating a constant flow.

What are the most important safety precautions to take when digging for underground irrigation repairs?

Always call 811 (or your local 'dig safe' number) a few days before you dig to have underground utility lines marked. Wear sturdy gloves to protect your hands from debris and tools. Dig carefully and by hand when you get close to pipes or marked lines to avoid damaging them or other utilities.

Transcript
Hide

the next thing you need to do is make sure that you flush out the irrigation system so that you can remove any dirt or debris that may have been introduced during the repair process you don't want those to end up in your drip emitters because they're going to clog them up and they're not going to function properly so you're going to remove the cap or the end piece whatever you have at the end of your drip irrigation line so the water can flow out the end and you're going to let it run for 30 to 40 seconds to make sure everything's flushed out once it's flushed out put the cap on clip it back down and test it and make sure there's no leaks i like to place a rock or something underneath the end of the hose if you don't have someone to help you that way water doesn't go back in and pull in dirt and debris with it when you turn off the water after flushing this keeps it up off the ground where it's going to be clean crimping style end cap put that back on so that the water won't come out anymore and now we're ready to test the system and make sure we have no leaks

Auto-generated transcript. May contain errors.