Skip to main content

Install Skirt Boards — Install the Skirt Board

Beginner4 hours

Part of project

How to Scribe and Cut a Stair Skirt Board to Fit · Step 5 of 5

Helpful?

In this video

Align the primed and painted skirt board pieces along the staircase. Use super glue to join the ends of any MDF pieces that need to be butt-joined to extend the length of the skirt board. Using a putty knife, carefully lift and position the skirt board into place against the wall and steps. Secure the skirt board by shooting 2-inch brad nails into the wall, ensuring you hit the studs for a strong hold. Continue this process along the entire length of the skirt board for both sides of the staircase.

40.8K views327
Inside Carpentry

321K subscribers

View Channel

FAQs

What specific tools are essential for accurately scribing a stair skirt board?

The Bullet Tools Stair Step Scribe 2 is crucial for transferring the exact stair profile to your skirt board, ensuring a snug fit. A good quality pencil for marking and a reliable measuring tape are also indispensable for precise measurements. For cutting, a jigsaw will be your primary tool for intricate angles.

Is this project truly beginner-friendly, and can it be completed within the estimated 4 hours?

While rated beginner, patience and precision are key. The scribing and cutting steps require careful attention, and mistakes can be costly. For a first-timer, 4 hours might be tight, especially if you need to troubleshoot or make small adjustments. Allow for extra time, particularly for dry fitting and fine-tuning cuts.

What's the biggest mistake beginners make when cutting the skirt board, and how can it be avoided?

The most common mistake is cutting too much material, as you can't add it back. Always cut slightly outside your scribe line and then use a block plane or sandpaper to slowly shave down to the line for a perfect fit. Remember the adage, "Measure twice, cut once," and apply it rigorously to this project.

Can I use materials other than cellular PVC for the skirt board, and what are the pros and cons?

Yes, solid wood (like pine or oak) or MDF are common alternatives. Cellular PVC, like the Veranda trim suggested, offers excellent moisture resistance and stability, making it good for varying humidity. Wood can be stained to match existing trim but may be more prone to warping or shrinking if not properly acclimated before installation.

Transcript
Hide

i used super glue to join the ends of the mdf together and used a putty knife to lift one side up into position then i shot it with two inch brad nails making sure to hit the studs

Auto-generated transcript. May contain errors.