Skip to main content

Mark Initial Stair Profile — Transfer Stair Profile to Skirt Board

Beginner4 hours

Part of project

How to Scribe and Cut a Stair Skirt Board to Fit · Step 2 of 5

Helpful?

In this video

Begin by positioning a piece of baseboard trim against the wall at the base of the stair. Using a black marker, draw a horizontal line on the baseboard to indicate the top edge of the stair tread. Next, move the baseboard and place it vertically against the wall where the stair riser meets the floor. Draw a vertical line on the baseboard, extending downwards from the previously marked horizontal line, to define the point where the baseboard will meet the floor at the bottom of the riser. These two lines establish the initial profile of the stair step on the baseboard.

21.7K views276
Inside Carpentry

321K subscribers

View Channel

FAQs

What specific tools are essential for accurately scribing a stair skirt board?

The Bullet Tools Stair Step Scribe 2 is crucial for transferring the exact stair profile to your skirt board, ensuring a snug fit. A good quality pencil for marking and a reliable measuring tape are also indispensable for precise measurements. For cutting, a jigsaw will be your primary tool for intricate angles.

Is this project truly beginner-friendly, and can it be completed within the estimated 4 hours?

While rated beginner, patience and precision are key. The scribing and cutting steps require careful attention, and mistakes can be costly. For a first-timer, 4 hours might be tight, especially if you need to troubleshoot or make small adjustments. Allow for extra time, particularly for dry fitting and fine-tuning cuts.

What's the biggest mistake beginners make when cutting the skirt board, and how can it be avoided?

The most common mistake is cutting too much material, as you can't add it back. Always cut slightly outside your scribe line and then use a block plane or sandpaper to slowly shave down to the line for a perfect fit. Remember the adage, "Measure twice, cut once," and apply it rigorously to this project.

Can I use materials other than cellular PVC for the skirt board, and what are the pros and cons?

Yes, solid wood (like pine or oak) or MDF are common alternatives. Cellular PVC, like the Veranda trim suggested, offers excellent moisture resistance and stability, making it good for varying humidity. Wood can be stained to match existing trim but may be more prone to warping or shrinking if not properly acclimated before installation.