Skip to main content

Test Fit the Straight Skirt Board — Dry Fit and Adjust

Beginner4 hours

Part of project

How to Scribe and Cut a Stair Skirt Board to Fit · Step 4 of 5

Helpful?

In this video

With the skirt board cut according to the measurements and angles, test fit it on the straight wall. It should align perfectly with the pencil line and have tight connections at the top and bottom. The presenter points out that a slight gap (e.g., 1/16th of an inch) above the marked line is acceptable as it allows for minor adjustments and will be covered by the riser. The goal is to ensure consistency along the entire length.

196.6K views5.1K
Inside Carpentry

321K subscribers

View Channel

FAQs

What specific tools are essential for accurately scribing a stair skirt board?

The Bullet Tools Stair Step Scribe 2 is crucial for transferring the exact stair profile to your skirt board, ensuring a snug fit. A good quality pencil for marking and a reliable measuring tape are also indispensable for precise measurements. For cutting, a jigsaw will be your primary tool for intricate angles.

Is this project truly beginner-friendly, and can it be completed within the estimated 4 hours?

While rated beginner, patience and precision are key. The scribing and cutting steps require careful attention, and mistakes can be costly. For a first-timer, 4 hours might be tight, especially if you need to troubleshoot or make small adjustments. Allow for extra time, particularly for dry fitting and fine-tuning cuts.

What's the biggest mistake beginners make when cutting the skirt board, and how can it be avoided?

The most common mistake is cutting too much material, as you can't add it back. Always cut slightly outside your scribe line and then use a block plane or sandpaper to slowly shave down to the line for a perfect fit. Remember the adage, "Measure twice, cut once," and apply it rigorously to this project.

Can I use materials other than cellular PVC for the skirt board, and what are the pros and cons?

Yes, solid wood (like pine or oak) or MDF are common alternatives. Cellular PVC, like the Veranda trim suggested, offers excellent moisture resistance and stability, making it good for varying humidity. Wood can be stained to match existing trim but may be more prone to warping or shrinking if not properly acclimated before installation.

Transcript
Hide

be cut at 50 degrees so I've got the board cut now I haven't test fitted it yet so we're going to see how I did normally whenever I cut these this system the way I do it they turn out pretty much perfect every time so I can see down here I'm lined up and then up here I'll just bump that up a little bit so you guys can see that pencil line there we want it to be dropped in place and bottom and top the whole way up you can see that we're following the pencil line I've got a 16th of space right here I intentionally did that just to give me a little bit of margin for air but my Riser will end up covering all that so it's no big deal and then this like I said I wanted this to be three quarters of an inch high and I'm going to cut this off it might be flush with the subfloor it might be up a little bit depending on how I decide to do that shoe rail detail later now we're on our open side which is a lot more complicated cutting this skirt board out basically first we're going to start by doing the exact same process that we just did we're going to cut the skirt board to length and Notch it around get

Auto-generated transcript. May contain errors.