Skip to main content

Secure Skirtboard — Install the Skirt Board

Beginner4 hours

Part of project

How to Scribe and Cut a Stair Skirt Board to Fit · Step 5 of 5

Helpful?

In this video

Once the bottom section is plumb, use a nail gun to begin securing the skirtboard. Start by nailing the bottom, then gradually work your way up the staircase. Continuously check the level of the treads and the plumb of the skirtboard with your torpedo level as you move upwards. You may need to slightly push or pull the skirtboard to achieve optimal alignment and tightness, ensuring the treads are level and the skirtboard is plumb. After nailing, fill any nail holes with wood filler.

111.2K views1.6K
Inside Carpentry

321K subscribers

View Channel

FAQs

What specific tools are essential for accurately scribing a stair skirt board?

The Bullet Tools Stair Step Scribe 2 is crucial for transferring the exact stair profile to your skirt board, ensuring a snug fit. A good quality pencil for marking and a reliable measuring tape are also indispensable for precise measurements. For cutting, a jigsaw will be your primary tool for intricate angles.

Is this project truly beginner-friendly, and can it be completed within the estimated 4 hours?

While rated beginner, patience and precision are key. The scribing and cutting steps require careful attention, and mistakes can be costly. For a first-timer, 4 hours might be tight, especially if you need to troubleshoot or make small adjustments. Allow for extra time, particularly for dry fitting and fine-tuning cuts.

What's the biggest mistake beginners make when cutting the skirt board, and how can it be avoided?

The most common mistake is cutting too much material, as you can't add it back. Always cut slightly outside your scribe line and then use a block plane or sandpaper to slowly shave down to the line for a perfect fit. Remember the adage, "Measure twice, cut once," and apply it rigorously to this project.

Can I use materials other than cellular PVC for the skirt board, and what are the pros and cons?

Yes, solid wood (like pine or oak) or MDF are common alternatives. Cellular PVC, like the Veranda trim suggested, offers excellent moisture resistance and stability, making it good for varying humidity. Wood can be stained to match existing trim but may be more prone to warping or shrinking if not properly acclimated before installation.

Transcript
Hide

up with a gap right there if by happenstance you do happen to not have it perfectly plumb it's not the end of the world you can still install the new applause and then then use a stave shim and I've shown that before in other videos it you're just gonna make a shim basically with a bevel on it and fill that gap and trim it with your utility knife and that gap will disappear but it's not an ideal situation you want to continue to use your torpedo level here as we go along make sure the tread is level across as you're nailing it off and then also your skirt board the two should coincide if your skirt board is plumb your tread should be level and vice versa but you will find that as you move your way down you may have to kind of push and pull the skirt board around to get those treads nice and level and tight where they need to be and if you remember our

Auto-generated transcript. May contain errors.