Skip to main content

Remove Caliper Bracket and Rotor

0:31
2:26
315.5K views

At 0:31 in

Brake replacement

What happens here

The brake system relies on a piston to apply force and slide pins to allow the floating caliper to move freely. If these components are seizing, it can cause uneven pad wear or brake issues. To access the rotor, you'll need to remove the caliper mounting bracket. Locate the two large bolts securing the caliper mounting bracket to the vehicle's knuckle and use a wrench to remove them. Once the bracket is off, carefully remove the old rotor. Rotors can sometimes be seized to the hub due to rust; a few firm taps with a hammer on the rotor's hat can help dislodge it. After removal, inspect the old rotor for any cracks, deep gouges, or severe scoring, which indicates it needs replacement. Also, visually inspect the parking brake shoes and hardware behind the rotor for any damage or excessive wear.

Goal: Remove the caliper mounting bracket and old rotor

Tools and materials

  • Hammer — Dislodging a seized rotor
  • Wrench — Removing the caliper mounting bracket bolts

What they say

Hide

don't squeeze themselves. This piston applies force, and these slide pins let the floating caliper move. And everything needs to apply pressure and release it properly. That's why I'm replacing mine. A new caliper isn't always needed when you need pads, but even with the new caliper and brand new pads, they still need a good surface to squeeze to. After the heat from my caliper locking up and these deep gouges right here, I'm going to go ahead and replace both of my rears. I'm going to go ahead and pull this caliper mounting bracket off to get access to my rotor. These two bolts right here hold your caliper mounting bracket on. These can be a pain to remove. Once you got the rotor off the hub, you want to inspect it for any cracks, gouges, or deep scoring. What's behind the rotor matters as well. I'm just going to spray

Auto-generated from the video audio.