Skip to main content

Install Caliper and Bleed Brakes

1:31
2:26
315.5K views

At 1:31 in

Brake replacement

What happens here

If you are reusing the old caliper, you'll need to compress the piston back into the caliper body using a C-clamp or a specialized piston compression tool. Then, slide the old caliper back over the new pads and rotor and secure it with the slide pins. If you are replacing the caliper, first ensure your new caliper has the bleeder screw located at the top to allow air to exit effectively. For the brake line connection, you will need two new copper crush washers – one on each side of the brake line's banjo fitting. Disconnect the old caliper from the brake hose, removing both old crush washers. Install the new banjo bolt with the new crush washers, connecting the brake hose to the new caliper. Once the new caliper is installed, the brake system will have air in it, so it must be bled. Attach a clear hose to the bleeder screw and submerge the other end into a bottle containing some brake fluid. Have an assistant pump the brake pedal 2-3 times and hold it down. While the pedal is held, crack open the bleeder screw, allowing fluid and air to escape into the bottle, then close it. Repeat this process until a solid stream of brake fluid, free of air bubbles, comes out. Throughout the bleeding process, continuously monitor the brake fluid reservoir in the engine bay and ensure it does not run dry, adding fresh brake fluid as needed.

Goal: Install new/reused caliper and bleed the brake system

Tools and materials

  • Banjo Bolt — Securing the brake hose to the caliper
  • C-clamp — Compressing the brake caliper piston (if reusing old caliper)
  • Clear Hose — Attaching to the bleeder screw for observing brake fluid during bleeding
  • Copper Crush Washers — Creating a seal at the banjo bolt connection
  • Empty Bottle — Collecting old brake fluid during bleeding
  • New Brake Caliper — Replacement brake caliper
  • Wrench — Opening and closing the bleeder screw
  • Brake Fluid — Refilling the reservoir and bleeding the system

What they say

Hide

I like to apply a small amount of grease. Get yourself a small C-clamp, compress your piston, and install your caliper. But, now what if you need to replace your caliper? Make sure you have the correct caliper with the bleeder on top so air can exit. You're going to want to put each one of these crush washers on either side of your hose. Disconnect your old caliper. Make sure you remove the crush washer on both sides. Insert your new banjo bolt. Put a crush washer on this side, and install your banjo bolt. But, just bolting this on and adding pads doesn't finish the job. We introduced air into the system, so now we got to bleed them. Get a hose and a bottle. 1 2 3 pump. Crack your bleeder. Close it. Pump. Crack the bleeder. Make sure that it's solid. And don't let your reservoir run dry. Put your wheel

Auto-generated from the video audio.