Skip to main content

Clean and Prep Components

1:09
2:26
315.5K views

At 1:09 in

Brake replacement

What happens here

Once the old rotor is removed, spray brake cleaner generously on the hub assembly and the parking brake components behind it to remove any dust, rust, or debris. Wipe it clean with a shop rag. Next, take your new brake rotor and spray both sides thoroughly with brake cleaner to remove any protective oils or coatings applied during manufacturing. Wipe the new rotor clean. Then, remove the old pad retention clips from the caliper mounting bracket. Inspect the old slide pins by pulling them out; if they are stiff or corroded, clean and re-grease them, or replace them if necessary. Lubricate the slide pins with a small amount of brake grease to ensure smooth movement.

Goal: Clean hub, new rotor, and prep caliper bracket components

Tools and materials

  • Brake Cleaner — Cleaning the hub, parking brake components, and new rotor
  • Brake Grease — Lubricating slide pins and pad contact points
  • New Brake Rotor — Replacement for the old rotor
  • Shop Rag — Wiping surfaces clean

What they say

Hide

got the rotor off the hub, you want to inspect it for any cracks, gouges, or deep scoring. What's behind the rotor matters as well. I'm just going to spray brake clean on mine, and then wipe it off. I'm going to prep my new rotor for install. Pop these clips off. You want to check these for rust and build-up, as well as check your slide pins. Pull the pin out and grease as needed. Once you got your new clips in, remount your caliper bracket. Put your brake pads in.

Auto-generated from the video audio.