Skip to main content

Inspect and Clean Pump — Check the Impeller

Beginner4 hours

Part of project

Sump Pump Repair · Step 3 of 5

Helpful?

In this video

Remove the pump from the sump pit to inspect it. Look for a broken impeller, warped base, or any other damage. Clean out any gravel or debris from the pump.

47.5K views344

FAQs

What are the most critical safety precautions I should take before starting any sump pump repair?

Always disconnect power to the sump pump at its circuit breaker before touching anything. Water and electricity are a dangerous combination, so ensure your hands are dry and avoid standing in water. Wear rubber gloves and eye protection to prevent injury from debris or contaminated water.

Do I really need all the specialized tools listed, or can I get by with basic household tools?

While basic screwdrivers and pliers are useful, a voltage tester is essential for safely verifying power. Tools like a drum auger or pipe wrench are specifically designed for clearing stubborn clogs in the discharge line or safely handling pump connections. A drill pump can be invaluable for quickly bailing out water, making the job cleaner and faster.

My sump pump runs continuously; what's the most common cause of this, and how can I fix it?

A constantly running sump pump usually indicates a stuck float switch or a blockage in the discharge line. First, disconnect power and check the float switch for any debris or obstructions preventing it from falling. If the switch is clear, the discharge line might be clogged, requiring the use of a drain snake to clear it out.

The pump motor hums, but no water is being discharged. What should I check first?

If your sump pump motor hums but doesn't move water, the impeller is likely jammed with debris or damaged, or the discharge line is severely blocked. After disconnecting power, access the impeller area and carefully clear any obstructions. If the impeller is clear, then focus on clearing the discharge line with a drum auger.

Transcript
Hide

results in the expulsion of well nothing so my next question is is there something wrong with the pump itself I don't know so you know you do a little bit of looking around on the on the youtubes and it could be that because of all this whirling around of water that there's something wrong with the pump perhaps the impeller is broken on the bottom of it and that's why this water is just whirling around so let's pull the pump out our pump looks a little odd and the reason it looks odd is because it has a plastic base and that plastic base is deformed it is warped it doesn't sit flat so when our pump runs water is expelled from these warped areas now is this just something that happens to be going on at the same time where is this the cause of our problem at the moment I don't really know what I did do is I took it apart and I tried to get all the goo out of there I noticed there was a bunch of gravel in there so I cleaned all that gravel out and then we hooked the pump back up plugged it back in restarted the pump we have the same

Auto-generated transcript. May contain errors.