Skip to main content

Check Water Level and Test Float Switch — Inspect the Float Switch

Beginner4 hours

Part of project

Sump Pump Repair · Step 2 of 5

Helpful?

In this video

If the float isn't physically obstructed, check the water level in the sump basin. If the water level is too low to activate the float, manually pour water into the basin to raise the float and see if the pump operates. This tests the float's ability to trigger the pump when submerged. Additionally, if the float is suspected of being stuck due to raw particles or algae buildup on the valve, try gently pressing and pulling on it to dislodge any blockages. For more persistent grime, clean the float switch with a wet cloth to ensure smooth operation. If these attempts to unstick or clean the float fail, you may need to consider removing the float switch for a more thorough cleaning or complete replacement.

16.9K views39

FAQs

What are the most critical safety precautions I should take before starting any sump pump repair?

Always disconnect power to the sump pump at its circuit breaker before touching anything. Water and electricity are a dangerous combination, so ensure your hands are dry and avoid standing in water. Wear rubber gloves and eye protection to prevent injury from debris or contaminated water.

Do I really need all the specialized tools listed, or can I get by with basic household tools?

While basic screwdrivers and pliers are useful, a voltage tester is essential for safely verifying power. Tools like a drum auger or pipe wrench are specifically designed for clearing stubborn clogs in the discharge line or safely handling pump connections. A drill pump can be invaluable for quickly bailing out water, making the job cleaner and faster.

My sump pump runs continuously; what's the most common cause of this, and how can I fix it?

A constantly running sump pump usually indicates a stuck float switch or a blockage in the discharge line. First, disconnect power and check the float switch for any debris or obstructions preventing it from falling. If the switch is clear, the discharge line might be clogged, requiring the use of a drain snake to clear it out.

The pump motor hums, but no water is being discharged. What should I check first?

If your sump pump motor hums but doesn't move water, the impeller is likely jammed with debris or damaged, or the discharge line is severely blocked. After disconnecting power, access the impeller area and carefully clear any obstructions. If the impeller is clear, then focus on clearing the discharge line with a drum auger.

Transcript
Hide

Pump float stock the first thing you should consider doing is checking the water level in the pump spacing pour some water into the Basin to raise the float and operate the pump if the water level is lower than the flip next remove the float switch you can also try cleaning the float or adjusting its position to keep it from sticking if none of these works you may need further examination you'll need a screwdriver a wrench a hammer and a replacement float to properly inspect and repair the jammed Sump Pump float firstly remove the pump cover and check for blockages check if the pump is getting power then test the float switch by lifting it and checking its movement and lastly make sure the float switch is not blocked by debris the Sump Pump float is stuck only if the float is not damaged if the sump pump floats stuck due to Raw particles or algae buildup on the valve clean it with a wet cloth try gently pressing and pulling on it to dislodge it clear the blockage and try again if the float has become stuck due to debris or something caught in the valve

Auto-generated transcript. May contain errors.