Skip to main content
Stesso

Configure Spray Gun and Test

3:10
5:45
275.6K views

At 3:10 in

Operating a Titan 440i airless sprayer. Airless Sprayer Instructions.

Watch on YouTube

What happens here

Increase the pressure on the sprayer using the pressure valve to an appropriate setting for spraying. The video suggests setting it about halfway to the highest position. Next, attach a 6-inch gun extension to your spray gun for better reach and control. Then, insert your chosen spray tip, specifically a Graco Rac X 210 tip is used in the video, into the tip guard. Hand-tighten the tip guard firmly onto the gun extension. Airless sprayer tips and guards are designed to be hand-tightened without the need for additional tools, ensuring a tight, leak-free seal. Finally, test the spray by briefly pulling the trigger into a waste bucket or a practice surface to confirm the pattern and ensure proper pressure.

Goal: Prepare the spray gun for painting and ensure proper spray pattern.

Tools and materials

  • 6-inch Gun Extension — Extending the reach of the spray gun for ergonomic use
  • Spray Tip Graco Rac X 210 — To create the paint spray pattern
  • Tip Guard — To protect the spray tip and prevent injury
  • Titan 440i Airless Sprayer Titan — The equipment to be used for spraying

What they say

Hide

the line. Now that it's all ready to go, we turn our pressure up to approximate the highest position. And we usually set it about halfway to the end. We're going to start off with we always start off with our gun with a 6-in gun extension on it for convenience. We put our rack tip on guard. We're going to be spraying the trim with the Rack X 210 tip. We'll install the tip into the guard. And it's a handtight guard and tip. So you don't have to use any tools to tighten them up and it won't leak. Then test our spray. It's ready to spray. Make sure our air

Auto-generated from the video audio.