Skip to main content
Stesso

Assemble Cooler Compartment Box

1:33
7:38
35.3K views

At 1:33 in

Built-In Camping Grill with Cooler Cart

Watch on YouTube

What happens here

Utilize the previously assembled L-shaped corner brackets and the prepared side panels. Apply wood glue to the joining surfaces and secure the side panels to the corner brackets using 1-1/4 inch screws and a cordless drill. This process forms the main wooden enclosure for the cooler. If any panel is slightly too long, use a table saw to carefully trim it to the correct length for a perfect fit.

Goal: Construct the main wooden enclosure that will house the cooler.

Tools and materials

  • 1-1/4 inch Screws — Securing the panels to the corner brackets
  • Cooler Side Panels — Forming the walls of the cooler compartment
  • Cordless Drill DeWalt — Driving screws during assembly
  • L-shaped Corner Brackets — Forming the structural corners of the compartment
  • Table Saw Magna — Trimming panels to exact size if needed
  • Wood Glue — Strengthening the joints

What they say

Hide

found that going over all the edges with a 3/8 round over bit gave it a really nice clean look once I was ready I then used a little bit of wood glue and some screws our inch and a quarter long and I started assembling each side panel at a time and really started watching this project come to life now based off of my clue dimensions the last and final panel was an inch and a half too long so I just brought the entire project to my table saw and just trimmed it right off now for the bottom part of this cooler stand I needed something that would not allow

Auto-generated from the video audio.