Skip to main content
Stesso

Extend Sensor Wiring Harnesses

6:53
38:07
46.5K views

At 6:53 in

Budget Turbo Yukon XL "Uncle Rob" Final Assembly! Downpipe Fab & Wastegate Plumbing (Ready to Rip!)

Watch on YouTube

What happens here

The presenter explains how he extended the IAT sensor wiring harness by cutting and soldering additional wire, then covering it with wire loom. He mentions that the O2 sensor wiring was also extended in a similar fashion. He found melted wire loom in a trash can, which he repurposed for this task. He also demonstrates how to avoid cutting the O2 sensor wiring by pulling the harness through the firewall if enough slack is available.

Goal: Extend the IAT and O2 sensor wiring harnesses for proper relocation.

Tools and materials

  • IAT Sensor Wiring — To be extended
  • O2 Sensor Wiring — To be extended
  • Solder — Creating secure electrical connections
  • Soldering Iron — Soldering wire connections
  • Wire Cutters — Cutting wires
  • Wire Loom — Protecting the extended wires

What they say

Hide

myself to run some wires so now i'm working on extending the iat wires i read that it was the two on the end the brown one and the black one also confirmed by the same ones ashton did on his truck so rather than test it i just ran with it trusted it i cut these pulled them back through the loom a little bit at least to get them back to here and extended them to go room plug in over here uh if you really wanted to be superfly you could trace this the whole way back through here and pull it out not have to add any wire at all but i'm not gonna do that also i found some some wire loom here it's um kind of melted found it in the trash can actually i'm not proud of it but like i'm not really ashamed of it either so looks good to me

Auto-generated from the video audio.