Skip to main content

Circular saw basics

2:04
129.6K views

Video by Living Lost

Living Lost

What happens here

This instructional guide covers essential tips and best practices for safely and effectively operating a circular saw. It delves into crucial aspects such as proper material support, accurate blade depth setting, understanding kerf, selecting the appropriate blade for different materials, safe blade changing procedures, techniques for cutting plywood, and making precise bevel cuts.

Transcript

Hide

Before you use a circular saw, here's a few things you should know. If your wood closes around the blade, it can pinch it and throw the saw backwards. And that's why supporting your material is so important. But even with your wood supported, you don't need all this blade hanging below it. Adjust your depth so the teeth extend roughly a quarter inch below your material and lock it in. And never pin this guard open. But even with the blade depth set correctly, how you hold the saw matters as well. Whenever possible, keep the wider part of the shoe supported for better balance and control. Keeping your saw stable doesn't guarantee a straight cut. For a straight crosscut, use your speed square as a guide. But there's one more thing you need to account for. And that's kerf. That's the material your blade removes when it makes a cut. So always cut on the waste side of your line. Before making your cut, bring your saw up to full speed and let the blade do the work. The blade that you're using can make a difference as well. A lower tooth count blade like this one here cuts very fast, but leaves the cut very rough. A blade like this works very well for cutting your dimensional lumber. But a blade with more teeth like this one give you a cleaner finish, especially on plywood. Whenever you go to change a blade, make sure that it's installed in the correct direction. Notice this arrow going this way and this arrow going this way. It's also important to know that you have the correct arbor size and the right blade rated for the RPMs of your saw. Hold in your button and tighten down your blade. And cutting plywood presents its own set of challenges. Get some sacrificial 2x4s to support your plywood. And support it on both ends so the plywood doesn't sag and pinch your blade. Mark where you want to cut, chalk a line, set the depth of your blade. It's okay to cut into your sacrificial 2x4. Your saw also has a notch that lets you line up your blade with the line that you need to cut. Line up your notch, keep your shoe flat, and let's get after it. But most circular saws don't cut just straight up and down. They cut from zero all the way up to 45, and in my case, 50. Just remember your blade's position changes when you tilt it. So line your 45 notch up with your mark and make a cut. And that comes in really handy when you want to make French cleats. Whether you're cutting plywood or dimensional lumber, keeping your work piece supported makes all the difference. Anyways, I'll catch you guys later. Peace.

Auto-generated from the video audio.