Layout Footings and Install Post Bases

1:24

15:02

366.6K views

At 1:24 in

Why patio roofs fail - and how to build them right!

Watch on YouTube

What happens here

Measure out the desired projection of your patio roof from the house structure (e.g., 7 feet in the video). Mark these points on the ground using spray paint. Dig footings for your support posts, ensuring they are below the local frost line and of an appropriate diameter as per building codes. Drill into the concrete footing using a hammer drill and a concrete drill bit. Install a wedge anchor into the drilled hole. Attach a post base bracket to the bottom of your post and then secure the post base to the wedge anchor.

Goal: Establish the foundation for the support posts, ensuring proper depth and secure attachment.

Tools and materials

Concrete drill bit — Creating holes in concrete for wedge anchors
Hammer drill Milwaukee — Drilling into concrete footings
Impact driver — Driving screws to attach the post to the base
Lumber — The vertical support posts
Post base bracket — Connecting the post to the footing
Post hole digger — Digging the footings for the posts
Spray paint — Marking post locations on the ground
Tape measure — Measuring out the roof projection and marking locations
Wedge anchor — Securing the post base to the concrete footing

What they say

(792 characters)

Hide

your studs. Then we'll measure out from our structure. In this case, I'm doing 7 ft. Now I'm going to mark the ground in two spots. The diameter of your pier needs to be a certain size, and these footings need to be dug below your frost line. We'll drill out our footing. This style counts on drilling down into the concrete and holding from uplift. For this post space, we'll install a wedge anchor. The wedge style expands on the bottom, and this is what keeps it from pulling out. So now when the post gets attached, and this beam gets installed, your beam and your post handles all your downward loads and uplift forces. When installing connectors and hangers, you need to be sure you're using the proper nails or screws. If you just use a random screw or a deck screw that is not tested,

Auto-generated from the video audio.