Skip to main content
Stesso

Review Tools and Final Demonstration

12:04
13:36
16K views

At 12:04 in

Werner Ladder Leveler Review | Best Levelers for Ladders

Watch on YouTube

What happens here

After successfully installing the Werner Level Safe Pro ladder leveler, the presenter briefly reviews all the tools required for the project: a hacksaw, rasp/file, 7/16" box wrench, 7/16" socket wrench, 5/16", 10mm, and 7/16" sockets, 1/4" and 1/8" drill bits, a tape measure, a drill, and a Sharpie marker. He then showcases the fully installed leveler by demonstrating its self-leveling action on uneven ground, confirming that the bubble level shows a safe, level position before climbing. He reiterates the safety and convenience benefits of the new system.

Goal: Confirm proper installation and demonstrate the functionality of the new ladder leveler.

Tools and materials

  • 1/4" Drill Bit — Drilling larger holes
  • 1/8" Drill Bit — Drilling smaller holes
  • 10mm Socket — Specific bolt size for assembly
  • 5/16" Socket — Specific bolt size for assembly
  • 7/16" Box Wrench — Tightening nuts
  • 7/16" Socket — Specific bolt size for assembly
  • Drill Bosch — Drilling pilot holes
  • Hacksaw Husky — Cutting the square rod
  • Rasp/File — Smoothing cut edges
  • Sharpie Marker Sharpie — Marking drill locations

What they say

Hide

fly section of the ladder rail I got my ladder leveler all installed I'm just going to go over the tools that you need I only thought I was going to need a couple tools but I opened up the instructions I ended up needing multiple tools the first thing I needed a hacksaw with a file to cut this little square Rod that goes in between the rungs so you'll need a hacksaw file socket wrench with a SE 7/16 inch box wrench I had three sockets that I used I used a 5/16 I used a 10 mm and I used a 7/16 you needed two drill bits a/4 in and an e drill bit to drill um multiple holes I needed a tape measure um obviously a drill and then a Sharpie marker highly recommended because you're going to be marking holes on the ladders and the Sharpie marker the tip of it kind of just centers itself you know right in the hole of this template so it worked out perfectly so those are the tools that I use to get this thing all installed

Auto-generated from the video audio.