Skip to main content

Copper Soldering

0:48
1:39
150.6K views

At 0:48 in

Plumbing connections

What happens here

For cost-effective and permanent copper connections, soldering is a common method. Start by thoroughly cleaning both the outside end of the copper pipe and the inside of the copper elbow fitting using a pipe cleaning brush to remove any oxidation or debris. Next, apply a thin layer of plumbing flux to both cleaned surfaces. Press the copper pipe into the elbow fitting. Using a propane torch, heat the joint evenly until it reaches the appropriate temperature. Then, touch the solder to the heated joint, and capillary action will draw the molten solder into the gap, creating a strong seal.

Goal: Create a permanent, cost-effective copper connection through soldering.

Tools and materials

  • Pipe Cleaning Brush — Cleaning the copper pipe and fitting surfaces
  • Propane Torch — Heating the copper joint to melt the solder
  • Copper Elbow Fitting — Connecting two pieces of copper pipe at an angle
  • Copper Pipe — The main component for connection
  • Plumbing Flux — Cleaning and preparing copper surfaces for soldering, promoting solder flow
  • Solder — Creating the permanent seal in the copper joint

What they say

Hide

just push to connect. No crimping and no soldering. But, these can get really expensive when you're doing a lot of plumbing. That's where soldering comes in. Clean your pipe and your fitting. Apply your flux, press on your fitting, heat your joint, and watch capillary action do its thing. But, what if you're somewhere you can't safely use a torch? That's where these press fittings come in. Insert your copper into the fitting, open your jaws, press the button, and watch the jaws do

Auto-generated from the video audio.