Skip to main content
Stesso

Cut Plywood Panels for Carcass

1:17
19:28
56.7K views

At 1:17 in

I Built An Expensive Home Depot Vanity For $300

Watch on YouTube

What happens here

Carefully feed the 3/4-inch maple plywood sheet through a table saw to rip it down into the required widths for the vanity's bottom panel, two side panels, and various internal stretchers. Ensure all cuts are straight and accurate to guarantee a square assembly. Wear appropriate safety gear like hearing protection and safety glasses.

Goal: Using a table saw, precisely cut the 3/4-inch maple plywood into the main components for the vanity carcass, including the bottom, side panels, and internal stretchers.

Tools and materials

  • Hearing Protection
  • Safety Glasses
  • Table Saw

What they say

Hide

little bit of ump let me slice these all up to make our 36in wide vanity and then uh we'll see if we can knock this thing out of car let's get into it we are 3/4 of the way through on our material so we have our bottom our sides these are stretchers pocket hole the stretchers to keep everything intact while not using too much material pocket hole the bottom so they can hold you

Auto-generated from the video audio.