Connect Spray Head and Install Hose Weight

squeezes good to go so then you want to grab the hose and you want to grab your sprayer head this side of the hose actually has a protective covering on it so to protect the o-ring don't take that off because you're actually going to be sticking that down this faucet but take this other side be gentle because it is plastic and you're screwing it into metal but just screw it in hand tighten it that's going to be good take this other side start feeding it through here all right then go back below remember the plastic nut that we had saved you want to take that and this is actually going to be a cover that's going to help protect this line right here right because this line is like a nylon line or it's something woven that woven plastic and it will fray and it will break if it keeps rubbing up against this metal right here all the time and so we just take this slide it over that set her up on there and that really just protects that like i said it's got a little lip on it that kind of tucks up in there that just helps that this piece right here that has that cover on it you're just gonna take that pop that off make sure it's out of the way of your supply lines okay and you're just gonna go ahead and push it right up into this piece until it clicks once it clicks it's in and it's not coming out this piece actually has if you look at this right here it's got a little eject button on it that you could eject and you could pop that back out if you needed to this is a great little feature for an easy hookup and then you see this right here this little yellow band that is where this weight right here goes that we talked about earlier just put that in the middle give that a clip it actually clips right on it's not going to move and now it's giving this cable or hose enough weight to keep your faucet head down and in place all right so then