Install the shower handle and trim plate following the manufacturer's instructions. This is typically done after the wall is finished. Ensure everything is aligned correctly and securely fastened.
You're viewing a step from: Install a Shower Valve at the Correct Height: A Step-by-Step DIY Guide
This DIY guide details the steps to install a shower valve at the correct height. First, turn off the water supply and drain the pipes. Then, access the shower plumbing area by carefully cutting an access panel, using a stud finder to avoid damaging the wall framing. Install blocking between the studs to securely mount the valve, adjusting the height as needed. Solder the copper pipes to the valve or connect PEX, ensuring secure and leak-free connections. Slowly restore the water supply and check all connections for leaks. Finally, install the trim kit onto the valve, ensuring correct alignment and secure fastening.
Install a Shower Valve at the Correct Height: A Step-by-Step DIY Guide
View Full ProjectRelated Videos
Step 1: Turn Off the Water Supply and Drain Pipes
Step 2: Access the Shower Plumbing Area
Step 2: Access the Shower Plumbing Area
Step 2: Access the Shower Plumbing Area
Step 3: Install the Shower Valve Blocking
Step 4: Solder Copper Pipes (or Connect PEX)
Step 4: Solder Copper Pipes (or Connect PEX)
Step 5: Test for Leaks
Step 5: Test for Leaks
Step 5: Test for Leaks
Step 6: Install Shower Trim Kit
Step 6: Install Shower Trim Kit
Start your project
chat with your ai