Skip to main content
Stesso
Project

Shut off the water valve — Turn Off the Water Supply

Beginner45 mins

Part of project

Delta Shower Head Installation: A Step-by-Step Guide · Step 1 of 5

Helpful?

In this video

Locate the water shut-off valve, typically found on the wall behind the toilet. Turn the valve to the off position to stop the flow of water to the toilet. For a pull-valve as shown, pull it out until it clicks. For a turn-style valve, turn it clockwise until it stops.

Goal: Shut off the water supply to the toilet.

Used in this video

  • Shut-off Valve (Power Source: Manual) — Stopping the water supply to the toilet.
744.0K views6.0K1 minute
Lowe's Home Improvement

1.3M subscribers

View Channel

FAQs

What specific tools and materials are essential for installing a Delta shower head, besides the new head itself?

You'll definitely need an adjustable wrench to remove the old head and tighten the new one. Crucially, have Teflon tape on hand for a watertight seal, and a soft cloth (like a microfiber cleaning cloth) to protect the finish of your new Delta shower head when using the wrench.

What is the most important safety precaution to take before beginning to replace my Delta shower head?

The absolute most critical step is to turn off the main water supply to your shower or, if possible, to your entire home. This prevents unexpected water sprays or potential flooding once you start removing the old shower head from the arm.

My newly installed Delta shower head is leaking around the connection point. What's the first thing I should check?

A leak usually indicates an issue with the seal. First, ensure you applied enough Teflon tape (typically 3-5 wraps clockwise) and that it's seated properly. Then, gently tighten the connection further with your adjustable wrench, making sure to protect the finish with a cloth.

The project mentions 45 minutes for a beginner. Is this realistic for someone who has never installed a shower head before?

Yes, 45 minutes is a realistic estimate for a beginner, assuming you have all your tools ready and follow the steps. Most of the time is spent carefully removing the old head and ensuring a good, leak-free seal with the new one. Don't rush applying the Teflon tape.

Transcript
Hide

So first step in this project is you're going to want to come down here and of course just make sure your water is shut off. In our case it's a pull valve, you're just going to pull that until it pops. Sometimes you'll see a valve that's round here, you're going to turn that clockwise until the stop and then you can flush to make sure that your water is shut off.

Auto-generated transcript. May contain errors.