Install New Flush Valve

let's try to get this all cleaned up when going with the new installation we are going to start with the flush valve itself okay check her out this bad boy is going to be the first thing to go in we are going to leave this red gasket on we're going to take this friction ring that's what this this is you know remember on the collar it was plastic this is just a cardboard friction ring it goes with this knot and just allows you to get a good tight seal on this we're going to take this we're going to put this in here and we're going to kind of put it at like a 45 okay that way it's not blocking one of the bolt holes over here you can access both of those and just get that at a 45 towards the back now we're going to flip it around we get that there you might want to hold it from the back side just to keep it in place that way you're going to ensure a good tight seal and just snug this up it says when you're installing the mounting nut on this fill valve it says hand tighten mounting nut only i'm going to tell you some people's hand tight is way different than others right so i like to put just a little bit of a snug on it guys and that's what we're looking like and that's in there it's tight it's not going anywhere