Skip to main content
Stesso

Create and Install Wood Inlays

1:45
4:39
37.5K views

At 1:45 in

Rare Earth Magnet Cutting Board

Watch on YouTube

What happens here

Using a table saw equipped with a dado stack, cut shallow grooves (dados) into the surface of the cutting boards where the inlays will be placed. Ensure the width of the dado matches the thickness of the inlay strips. From contrasting wood, cut thin strips to fit precisely into these dados. Apply wood glue to the dado groove and the inlay strip, then firmly press the inlay into place. Use blue painter's tape to hold the inlay strips securely while the glue dries. Once dry, use a flush-cut saw to carefully trim any protruding inlay material flush with the board's surface. Finally, sand the inlaid areas with a random orbital sander (220-grit) to blend the inlay seamlessly with the main board.

Goal: This step adds decorative elements by cutting dado grooves into the boards and inlaying contrasting wood strips, then trimming and sanding flush.

Tools and materials

  • Dado Stack
  • Blue Painter's Tape

What they say

Hide

project looked just when I was ready to leave the project alone I felt that it was missing something so to give it that added Flair I decided to install a walnut piece inlay that would run across all the geometric pieces to symbolize that they all belong together like this is where they connect so to accomplish this I set up a dado stack which is an accumulation of different thicknesses of blades that are meant to chip away a large portion in a clean cut on your table saw you can also accomplish this using a rout that's perhaps with a three-quarter inch cutout bit and set it to about 1/4 inch depth that's what my inlay was I applied some type on three wood glue and I set the piece of walnut in and I taped it and let it dry overnight the next day when the pieces were dry I then removed the tape used the hand saw to trim off all the excess walnut inlay and then gave it that final sanding to make sure the inlay is flush with the cutting board or serving cheese plate as it should be now to give the cheese

Auto-generated from the video audio.