Tighten Mounting Bracket & Screws (Lock Nuts)

up here in place and then you have this little brass nut you're going to stick that right over the end of the pull out hose piece as well and just start threading that in place once you get that started you can grab the tool that delta provided slide that hose through there you can see that's why they make it with the uh end open and then you can just grab it i like to grab a hold of the two supply lines hold them tight and then just start spinning and man it's a lot of spinning these are very long-winded okay and as you start to get this a little bit tight what you want to do is then go up top grab this get it set up to where you want it because it's kind of tight down there but it's not too tight and this is gonna be right where it goes and then you're just gonna wipe that silicone off right just get your access off of there so now you can tighten this up the rest of the way and then tighten up your two screws okay and so then if your faucets moved at all you could do just a little bit more of adjustment clean up any more access silicone that might have squeezed out snug up those screws one last time just to make sure everything is super tight