Connect Hoses and Attach Nozzle

to make sure it's on in the on position. And then on this MITM power washer, the um pump actually has a pressure control valve. It's a 3000 PSI power washer. But if for some reason you wanted less PSI, there's a plus and a minus. You just want to turn this knob to the plus or the minus direction according to how much uh PSI you wanted. It'll go up to 3,000 and you can turn it down less. We very rarely ever change it. It's typically always set at 3,000 PSI. And then over here on this side is the pump, the quick release. The top is uh hooks up to the hose and then the bottom to the actually the wand that we actually spray the water out of. And then the bottom actually hooks up to the water source. And they just screw right on. This is a quick release. And the bottom one just screws right on. And that's uh the MITM power washer with a Honda engine. And the whole engine is pretty typical of all Honda engines and stuff. The power washer's got a quick release on the end here. We're going to put a quick release nozzle on just like that. It goes on and off. Once you hook up