Skip to main content
Stesso

Run and Secure Electrical Wire

0:59
1:24
394K views

At 0:59 in

Electrical roughed in

Watch on YouTube

What happens here

With all the necessary holes drilled and boxes mounted, feed the electrical wire (NM-B cable) through the holes in the studs, routing it towards each electrical box. Once the wire reaches a box, pound a cable staple into the stud immediately below the box to secure the wire. Ensure the cable staple is snug but not so tight that it pinches or damages the wire's insulation. Pull an ample amount of excess wire into the electrical box to allow for future connections and device installation; typically, 6-8 inches (15-20 cm) is sufficient. Coil the excess wire neatly inside the box to keep it organized and protected until the final wiring stage.

Goal: Route electrical wire through studs and secure it to electrical boxes.

Tools and materials

  • Cable Staples — Securing the electrical wire to the studs
  • Electrical Box — The mounted box where the wire will terminate
  • Electrical Wire — Carrying electrical current to devices
  • Hammer — Pounding in cable staples

What they say

Hide

stud. You could drill right through your wire. After you went through and drilled all your holes, run your wire. Once you got it close to your box, pound out the bottom of your box, slip your wire through, and pound in a cable staple. Take your excess wire, leave yourself room to play, roll it up, and stick it in your box ready for your outlet. That's how you do the rough-in part of electrical. So, anyways, I got stuff to do. Catch you

Auto-generated from the video audio.