Skip to main content
Stesso

Install and Test Plastic Expansion Anchor

0:09
1:37
37.8K views

At 0:09 in

Drywall anchors

Watch on YouTube

What happens here

The video begins by introducing the plastic expansion anchor, also known as a ribbed plastic anchor or conical plastic anchor. The creator advises checking the back of the packaging for specific installation instructions. First, a pilot hole is drilled into a drywall sheet using a cordless drill equipped with an appropriate drill bit (size as per anchor instructions). A crucial tip is provided: insert the screw about a quarter inch into the plastic expansion anchor before pounding the anchor into the drywall. This technique helps prevent crushing the anchor during installation. The anchor is then hammered in flush with the drywall. Finally, the screw is removed to prepare for the weight test. A bucket is attached to the anchor, and water is progressively added until the anchor fails, which occurs at roughly 60 lbs.

Goal: Install and test the holding strength of a plastic expansion anchor

Tools and materials

  • Bucket — Holding water to apply weight during the test
  • Cordless Drill Milwaukee — Drilling the pilot hole
  • Drill Bit — Creating the pilot hole for the anchor
  • Drywall Sheet — The surface into which the anchors are installed
  • Hammer — Tapping the plastic expansion anchor into the drywall
  • Plastic Expansion Anchor — The anchor being installed and tested
  • Screw — Used with the anchor for installation and holding weight
  • Water N/A — Adding weight to the bucket

What they say

Hide

Today, we're going to put these four drywall anchors to the test. First one up is this plastic expansion anchor. Always use the back of the box for recommended install. Quick tip for installing these plastic expansion anchors, put the screw in like a quarter inch before you pound it in. Helps you from crushing the anchor.

Auto-generated from the video audio.