Skip to main content
Stesso

Reassemble Handle and Filter

7:28
11:06
65.2K views

At 7:28 in

Cleaning A Graco Contractor II Gun. Repair an Airless Spray Gun.

Watch on YouTube

What happens here

Take the cleaned filter and insert it back into the handle piece. Then, screw the handle section back onto the gun body by hand until it is snug. Use the 5/8 inch wrench to tighten it fully. Finally, reattach the knuckle guard to the handle.

Goal: Attach the filter and handle back to the main gun body.

Tools and materials

  • 5/8 inch Wrench — To tighten the handle section
  • Filter Graco — To filter paint
  • Graco Contractor II Gun Body Graco — The main part of the gun assembly
  • Handle Piece Graco — The handle component of the spray gun
  • Knuckle Guard Graco — Safety guard for the handle

What they say

Hide

So now I'm going to take my handle my on the gun. Going to set it down from there. We're just going to push it on. The O-ring's fairly snug. Going to take my filter that I've cleaned. Just stick my filter back inside. And then the side, the end, you can see sticks up and it'll set right in there. It grabs right onto the end. Going to screw my gun back down. And there's a pin right here that's going to get to a point where it won't go any higher. It's going to drop over that pin. Then I can use my handle. Once again, it's a wrench to tighten it up. Once it's good and tight, put my knuckle guard back on. And now begin assembling the top part of the

Auto-generated from the video audio.