Skip to main content
Stesso

Marking and Welding Crossover Pipe

11:17
23:22
158.4K views

At 11:17 in

Budget Turbo Yukon: I Got the CHEAPEST Crossover Manifold on the Internet! Uncle Rob Gets a Hot Side

Watch on YouTube

What happens here

The creator marks the metal pipe sections, emphasizing the importance of precise measurements and test-fitting before cutting. He then uses a TIG welder to tack weld three sections of the crossover pipe together. He explains that using three tack welds provides more stability than two, preventing the pipe from breaking if accidentally dropped. He also mentions the use of a cheap welding helmet.

Goal: Precisely cut and tack weld the crossover pipe sections.

Tools and materials

  • Marking Pen/Scribe — Marking cut lines on the pipes
  • Metal Pipe — Fabricating the crossover pipe
  • TIG Welder Fronius MagicWave — Tack welding and potentially final welding the exhaust components
  • Welding Helmet Vizor 4000 — Protecting eyes and face during welding

What they say

Hide

plain and simple i'm not exactly sure how well you're going to see what i'm doing here but i'm going to do it anyway get it up there nice and flush check my angle angle of attack here get some marks up there so i know where to attack it too so got everything filed lined up ready to rock i'm gonna tack it together with the old fronius magic wave [Music] i usually do three just for good measure because two you drop it you can bust it one way but if you have three relatively evenly spaced ones it's pretty good i apologize for the wind flapping around it's like the air pressure changes in here and blows these vent flaps so these woody d's i know i made this mark here i'm gonna go test fit it again and then hold my angle up to it so i can make sure this is the right place to cut it i'm doing this right so one i'm glad i did that i found out i can cut it up farther and get it closer to the drive shaft without hanging down

Auto-generated from the video audio.