Create Drawer Cavity and Drawer

What happens here

Take the smaller, front piece that was separated in Step 4. Carefully cut along the inner-most marked lines to remove the material that will form the actual drawer (3:20-3:41 shows the explanation, 3:42-3:49 shows the cut). This cut will create two pieces: the outer 'sleeve' that will house the drawer, and the inner block that will become the drawer itself. Mark the 'waste' portion (the core of the drawer) with an 'X' to avoid confusion. Then, on the inner drawer piece, cut out the back panel (3:50-4:02) so the drawer can be hollowed later.

Goal: From the front section of the organizer, cut the inner cavity for the drawer and simultaneously create the drawer itself.