Vinyl Wrapping Front Bumper

1:31

24:26

111.9K views

At 1:31 in

72 LSA Supercharged Monte Carlo Gets NASCAR Boom Tubes! Early 2000's Superspeedway Style!

Watch on YouTube

What happens here

Following the rear bumper, the professional wrapper applies vinyl to the front bumper. His strategy involves using a single piece of vinyl, first laying the top section, allowing the material to relax, and then carefully bringing it down over the bumper's contours. He points out the particular challenge of the complex curves around the fender areas, where the vinyl tends to bunch up. To address this, he uses relief cuts and meticulous application to ensure a smooth, flush finish with minimal, unnoticeable seams (ideally 1/8 to 1/16 inch).

Goal: Successfully apply gloss black vinyl to the intricate front bumper, minimizing seams and imperfections.

Tools and materials

Cutting Tool/Knife — Making relief cuts in the vinyl for complex areas and trimming excess material
Gloss Black Vinyl 3M 2080 — Covering the chrome bumper for a new aesthetic
Heat Gun — Relaxing the vinyl for easier application on curves
Squeegee/Applicator — Smoothing out the vinyl and removing air bubbles

What they say

(768 characters)

Hide

oh yeah that makes the car so what's your strategy going to be on the front one single piece right in the top first and then relax everything and bring it all down and then once i get to here we'll relief cut it lay this in and then bring the top down so i have like a real small eight to sixteenth inch seam right there hey you won't even notice that nope it'd be about impossible to stretch that over and get that to be flat a lot of fingering and stuff once you get into this area because there's the way the bumper comes down here and there just wants to bunch up send me your cars that looks so much better it's freaking ridiculous i've wanted to do this for years never never had it done but that 2083m stuff looks so much better than the old stuff print install

Auto-generated from the video audio.