Skip to main content
Stesso
Project

Connect Water Supply and Test — Reconnect Water Supply & Test for Leaks

Beginner3 hours

Part of project

New Toilet Installation: A Step-by-Step DIY Guide · Step 4 of 4

Helpful?

In this video

Connect the flexible water supply line to the fill valve inlet at the bottom of the new tank and to the shut-off valve on the wall. Hand-tighten the connections and then give them a slight turn with pliers to ensure they are snug. Slowly turn the water supply back on. As the tank fills, check all connections for leaks. Once the tank is full and the water stops running, flush the toilet several times. Thoroughly inspect the base of the toilet and all water connections for any signs of dripping.

Goal: Toilet Repair (Standard)

  • The water level in the tank can be adjusted by turning the screw on the fill valve float.

Used in this video

  • Pliers (Tool Type: Pliers, Pliers Type: Slip-joint pliers) — Tightening the water supply line connections.
40.6K views17915 minutes
Korky Toilet Repair

10K subscribers

View Channel

FAQs

What additional tools or materials, beyond the adjustable wrench and sponge, are highly recommended for a successful toilet installation?

A five-gallon bucket is crucial for collecting residual water from the old toilet. Also, have a utility knife for trimming bolt caps, rags for cleanup, and consider purchasing a new braided stainless steel supply line for optimal reliability and leak prevention.

What are the most crucial safety precautions and potential hazards I should be aware of during this DIY toilet installation?

The old toilet can be very heavy; always lift with your legs or ask for help to prevent back injury. Be extremely careful not to overtighten the mounting bolts or the tank bolts, as this can easily crack the porcelain fixture. Ensure the water supply is completely off before disconnecting anything to avoid water damage.

The project is rated 'beginner' with an estimated 3 hours. Is this realistic, and what factors might unexpectedly increase the project time or difficulty?

While 3 hours is a good estimate for ideal conditions, beginners should allocate more time, perhaps 4-6 hours, to avoid rushing. Rusted bolts, a damaged flange requiring repair, or discovering an uneven floor can significantly extend the project. Always be prepared for unforeseen challenges.

After installation, if my new toilet rocks slightly or I detect a leak, what are the most common causes and how should I troubleshoot them?

Toilet rocking often indicates an uneven floor or bolts tightened unevenly; use shims to stabilize if the floor is uneven. Leaks typically stem from an improperly seated wax ring, loose supply line connections, or an issue with the tank-to-bowl gasket (if applicable). Retighten connections carefully or inspect the wax ring if a leak persists at the base.

Transcript
Hide

Last but certainly not least time to put that pesky line back on All right, so it says all I can do now is fill it up Now we see them check for me All right, so I got the water turned back on outside Everything's plugged up. Nothing is leaking Now all I have to do is see how this fills and if it stops If it doesn't stop then we're obviously going to have an issue But it's supposed to stop right about now Oh, it stops And there is the water in there Water in there the float stops is completely adjustable at this turn. So if we want a more water in We could let more water in theoretically Actually It looks a little more because that's really not that much water This is a little more pressure in there All right You need 12, it's awesome You Word it works just fine

Auto-generated transcript. May contain errors.