Step 12 · Install Temperature and Pressure Relief Valve (T&P Valve)
Install the new T&P relief valve into the designated port on the water heater. Use pipe thread sealant on the threads of the valve to ensure a watertight seal. Tighten the valve securely with an adjustable wrench. Following local codes, attach a discharge pipe to the outlet of the T&P valve. This pipe must be made of approved material (usually copper or CPVC), be sized correctly, and run downhill to a suitable drainage point (like a floor drain or indirect waste receptor) or to within 6 inches of the floor. Do not cap, plug, or thread the end of the discharge pipe.