Skip to main content
Stesso
BrowseFeedExpertsMy Projects
Log inSign up
Stesso

Step 11 · Restore Utilities and Test

Once the tank is full and all connections are checked for leaks, you can restore the utilities. For gas heaters, turn the gas shut-off valve back on, aligning the handle parallel to the pipe. Then, follow the manufacturer's instructions to light the pilot light or start the electronic ignition. For electric heaters, turn the breaker back on at the electrical panel. Allow the water heater time to heat the water (this can take an hour or more depending on the heater size and type). Once the water is heated, check the temperature at a faucet. Monitor the unit for any leaks at the connections or from the tank itself. Test the temperature control to ensure it's set correctly.

Stesso home
SearchSearchBrowseBrowseFeedFeedMy ProjectsMy Projects
Log inLog inSign upSign up

Step 11 · Restore Utilities and Test

Once the tank is full and all connections are checked for leaks, you can restore the utilities. For gas heaters, turn the gas shut-off valve back on, aligning the handle parallel to the pipe. Then, follow the manufacturer's instructions to light the pilot light or start the electronic ignition. For electric heaters, turn the breaker back on at the electrical panel. Allow the water heater time to heat the water (this can take an hour or more depending on the heater size and type). Once the water is heated, check the temperature at a faucet. Monitor the unit for any leaks at the connections or from the tank itself. Test the temperature control to ensure it's set correctly.

Videos for this step

Final Checks and StartupFill Tank, Check Leaks, and Restore Power/GasFill Tank and Power On

Tools and Materials

← Project

Water Heater Installation

Step 11 of 13·1.8 hr left

Turn Off Utilities
15 minutes2 items
Drain the Old Water Heater
60 minutes3 items
Disconnect Plumbing and Venting
30 minutes3 items
Remove Old Water Heater
20 minutes2 items
Prepare the Installation Area
30 minutes2 items
Position the New Water Heater
20 minutes2 items
Connect Water Lines
30 minutes3 items
Connect Gas Line and Venting (Gas Heaters)
45 minutes5 items
Connect Electrical Wiring (Electric Heaters)
30 minutes3 items
Fill the New Water Heater
20 minutes1 items
11
Restore Utilities and Test
60 minutes2 items
12
Install Temperature and Pressure Relief Valve (T&P Valve)
20 minutes3 items
13
Final Inspection and Cleanup
30 minutes1 items
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.