Mount Shelf Brackets and Level

that went in pretty good so the one thing about these brackets is that all of them are different right if i zoom out here none of these are the same they are all handmade and they're just a little bit different now we've got this one in we'll just take it put the level on it make sure that it's straight straight line with the other ones okay that's good to go right there just tighten this down as tight as we can get it in place and we're gonna come over here to this side put this on up here get this leveled out this way come up a little bit that way all this once again here good to roll that worked out pretty well take the little guy get that marked same process we've took the little 1 8 put a hole in it now we're going to go up in size and we're just going to keep going up so i was going to go to the next size but that last remember what i was saying that last one that hole was a killer for this it destroyed this bit so we're just going to bump up one more size here and so i've actually never had the tile once split this way i mean it's been jacked up but you can see that just broke right off of there but it's not gonna matter because it's gonna be covered up anyway so we lucked out two more left and man hopefully that knocking on wood helped this is actually the first one that i've had that's not really been a hundred percent in level i mean it's almost a full bubble but i'm still going to try to take this side down a little bit let's just try to give that a little wacky let's see what that did looks like it dropped it a little bit there we go that looks way way way better let's zoom on in on that way better that bubble looks way better so now we're going to go ahead and we're just going to make sure that these are all straight again and that's straight and we're just going to mark our holes let's grab this little bad boy bam there bam there okay we'll do the same thing over here get that in the center get that hooked up it's weird this thing is misfiring that's it two more holes so then we just repeat the same process just drilling holes man just hoping to get two more holes out of this eighth inch bit right here safety glasses on so with drilling this i'm assuming it's the same principle as any other drilling i'm not positive but pressure and speed is going to give you the optimal drill through so i'm trying to not keep it gunned down the whole way not running it the whole time or full blast right and i'm also applying some pressure to the back side so…