Mark and Protect the Drilling Areas

they're pretty costly so and to put these in we're just going to be using these snap toggle bolts right these are togglers by snap toggle you've seen me use these before and you know they hold over a couple hundred pounds which that's the reason why i use them um i could have used something different but as my luck would have it where we mounted our brackets didn't hit one stud the whole time right so it's unfortunate on either side zero stud and we had to have some kind of wall mount and in my opinion these are the best i'll put a link for these snap toggles and also for some of these bosch um glass and tile drill bits like they really are nice i know that you know other people use different kind of drill bits i know they make diamond drill bits these days but i felt like i needed something with the precision of a point so you can see i've covered my light switch up here covered up with an old sour cream container just because i don't want any water getting on that so whenever i drill i've just been using a spray bottle and we put the tape on the wall that way it doesn't split out our tile as much keeping this on i think just kind of helps the tile not break up from being drilled now i'll show you the distance from here to here is two and a half so then i'm just going to measure down right here two and a half two and a half the way i've been doing this this first one up top was very important i measured from here to here with my tape and i got my center line and then i measured i wanted these to be 18 inches from center to center which means they're 17 inches from end to end so i just took that and made it eight and a half and eight and a half and made marks on tape that i had up here previously and i just kind of made a square and then i just leveled it up i started with this bracket right here and this one top screw i put that in i put a level over on this one got it exactly where i needed to get it made my mark that's the next one i drilled from there i was able to have these two brackets on with it level and then i was able to just drill there and there went down here and then i just went off of this everything kind of went off of this after that just bam down here did this one did this one got that level across there bam bam and i'm doing the same thing right now so came down here two and a half