Skip to main content

Install Stator, Rotor, and Control Box

7:45
12:53
450 views

At 7:45 in

The Greatest Trailer Invention I've Seen in Decades

What happens here

Begin the installation by removing the existing wheel hub and brake drum from the trailer axle. Place the stator component of the regenerative braking system over the spindle. Secure the stator flush against the brake backing plate using the three bolts and nuts provided in the kit. Next, carefully place the rotor over the stator and spindle, ensuring proper alignment. Route the two additional wires specific to the regenerative braking system through the grommeted holes located at the back of the backing plate, alongside the standard brake wires. Finally, mount the compact, fully potted (waterproof) control box, which is designed to fit conveniently inside the trailer's frame rail. Connect the wires from the regenerative axles to the control box, and then run the main power wire from the control box directly to the trailer's battery.

Goal: Proceed with the step-by-step installation of the regenerative braking system's stator onto the spindle, integrate it with the brake system, install the rotor, and mount the waterproof control box.

Tools and materials

  • Brake backing plate
  • Trailer axle and spindle
  • Trailer battery
  • Wire routing tools
  • Wrenches/sockets

What they say

Hide

All right, so we're at this point where we've got the hub off through. What's the difference between this and a normal brake job? >> Well, once you put your backing plate on, you're going to fit your stator over the spindle. In the kit comes with three bolts and four nuts. You put your three bolts through and you put your nut on the back obviously and the main thing with this kit is that you make sure that this your stator is sitting flush against the backing plate. All the wiring gets fished through the back of the backing plate. There's some holes with grommets in them in the back. >> So okay, so point at the wires cuz I can see them right here. Right here. Yep, that's your wires. >> This is it. Yep. >> That's it. So and then your brake wires. >> So you've got two extra wires and three extra >> No, just these two brake wires which is a which is standard for a brake job. This is your for your brakes. >> Yep. >> And then all you got here is your plug and play in. >> Right, that's so that's the two extra wires. >> it. This is it. That's all That's the only thing different. >> extra nuts, right? To hold the stator in place. >> That's correct. Yep. >> And that's the only difference between this and a normal brake job. >> That's it. That's it. >> So show me the control panel. >> So here's your controller. This is what converts it from AC to DC power. All you're going to do is this is fully potted so it can get wet and submerged. It's not going to hurt it. So this is designed to fit right inside the rail. Wherever you want to put it. >> [snorts] >> And then the wire that comes from the uh the other side gets plugged in here. It doesn't matter if you go which side you go to. It's all just plug and play and that's it. >> And then you just run it right up to the battery. >> just run it right up to the battery.

Auto-generated from the video audio.