Apply the Second Coat (Final Layout)

6:00

10:55

2.2M views

At 6:00 in

ROLLING WALLS FAST. How to paint a room in 1 hour. Fast painting hacks. DIY house painting.

Watch on YouTube

What happens here

For the final coat, the objective shifts to achieving a smooth, evenly coated, and fully opaque finish. Load the 18-inch roller with a generous amount of paint from the 5-gallon bucket. This coat should be applied more substantially than the initial skim coat. Start by positioning the loaded roller in the middle of a wall section, then roll the paint vertically. It is important to overlap each pass by approximately 25% to ensure full coverage and a consistent finish. The paint should be 'laid out' in a uniform direction, typically from top to bottom, to create a consistent texture and smooth appearance, working systematically across the wall while maintaining a wet edge to prevent visible lap marks. While less critical for light colors, precise 'lay out' is essential for darker colors where imperfections are more noticeable. The video also shows using a standard caulking gun with clear caulk for fine lines.

Goal: Achieve a smooth, even, and fully covered final paint finish

Tools and materials

18-inch Roller Frame with Nap Wooster — Applying paint to the wall
5-gallon Paint Bucket/Pan Wooster — Holding paint and loading the roller
Caulking Gun — Applying caulk to fill gaps and create smooth seams
Extension Pole — Facilitating comfortable reach during painting
Clear Caulk — Filling gaps along baseboards and trim for a seamless finish
Paint — Coating the walls with the final layer

What they say

(1,631 characters)

Hide

out and lay that final coat. So, doing the final layout on this thing, the process a little bit different. I'm not doing just a skim coat, but I'm going to do the same thing. I'm going to load up my roller. So, just load it up in my pan, and then I'm going to put it in the middle of the wall. And you can either go up or down, whatever is more comfortable for you. Sometimes I think uh I like going down a little bit better, but it doesn't really matter. Just set it in the middle of the wall. And typically you're going to start from either corner of the wall and you work your way to the opposite side. But for video purposes, I'm just in the middle of the wall right here. But just going to put it down. I'm just going to roll it down, up, and then back down again. And then I'm going to load up my roller again. Just load it up with a lot of paint. On your final coat, you want this to be pretty heavy. I'm going to overlap it about quarter. Go down, up, and then down again. And now I'm just going to lay this out. I always lay it out from top to bottom, just like that. And that's how you actually lay it out. In doing these light colors, the layout is not nearly as critical as doing a layout on dark colors. That's what's really important on here. You don't really have to be that critical with it. But come back over here. I can work the opposite direction now just for camera purposes. Overlap it about 25%. Down, up, down again. I'm going to load it back up. Make sure you load it up with a lot of paint. You can turn your roller to keep it from dripping to go down up and then down again. And now I'll just lay it out.

Auto-generated from the video audio.