Rolling Large Wall Sections and Laying Off

start right here on this wall and I'll show you what it looks like to roll this thing so we'll keep loading this thing not so I can feel that it's totally loaded up of paint getting pretty close well this thing absolutely saturated serve that get here by the sound with your board and if it's really dry it kind of makes a lot of sound motor hissing sound let's really wet you can just hear that that wet down instead of a kissing sounds that's starting to sound pretty good got to say load it up and I'm gonna start on the wall for the purposes of this video probably won't start the corn right there okay just start right here what T typically want to do is work from corner to corner around here let's start the middle because of the video camera you know is setup feel that way so what I'm going to do we'll just say like the corners you're right here I'm going to work this direction without I'm going to do is put my roller right in the middle of wall and then begin unload it in that direction just like that it'll load it up again does it already man on the paint and just give this thing saturated load it up again you can see you want to just keep loading this thing up to get a lot of paint on here there's one section right there load it up again move over a little bit and I'm not going to do my layout yet till I get a little bit lighter of a section move over a little more you got a pilot down here I can just work around without having to cut around it with a four inch snap I've been doing with my 18 inch border you always going to use an extension pullback you don't have to get on ladders and reach and use it this is just a little 2 to 4 foot extension hole so there I go cut that section and then we come back over here and I like to go from top to bottom laid out from top to bottom and lay it out and get up here as close as I can to the ceiling top to bottom and lay it out but we typically like to do is do our cuttings first we have those done first but just for video purposes I wanted to show you how to layout of all right here in this room lighting was best with everything in campers but you would definitely see that the ceilings cut in first and then we have roll up and past our ceiling plans to just move over and do another section you see any little holes or anything that you need spackle just make sure you spackle those holes just like that you've got another section down load up my roller a little bit and then I'm gonna Lake this section out I'll just go…