Skip to main content
Stesso

Install Drywall, Connect Fixtures, and Pass Inspection

21:30
39:51
184K views

At 21:30 in

Rewiring New Electrical in an Old House

Watch on YouTube

What happens here

With all new wiring installed and approved by an inspector, the walls are closed up with drywall. Once the drywall is in place, the final electrical fixtures are connected, including outlets, switches, and the recessed LED lighting. The recessed lights are installed by simply screwing them into the pre-wired connectors and pushing them into the ceiling. The main breaker panel is then secured with its cover. The final inspection involves checking the entire electrical system for proper installation, ensuring all outlets and lights are functional, and verifying compliance with all safety codes. The successful completion of this inspection signifies a safe and fully functional electrical system for the renovated house. The inspection also included verifying that neutral and ground wires were separated in the sub-panel, a key safety requirement.

Goal: After all wiring is installed and inspected, close up walls with drywall, connect the final electrical fixtures, and secure the breaker panel cover. The final step is to successfully pass a state electrical inspection, ensuring compliance with all safety and code regulations.

Tools and materials

  • Drywall Tools
  • Electrical Testers
  • Respirator Mask
  • Safety Glasses
  • Screwdrivers
  • Work Gloves
  • Breaker Panel Cover
  • Drywall Sheets
  • Electrical Outlets
  • Light Switches
  • Recessed LED Lights

What they say

Hide

upside down. What is this? Is this like a CIA listening wire? What is this? All right, so we got the drywall all cut out. We have a blank canvas. All the power has been stripped from here. There's no power outlets or power in the ceilings. Obviously, there's no recess lights. So, what I'm going to do now is to This is probably the second place that has the most amount of energy used after the kitchen cuz you're going to have your TV here. You're going to have lamps, all this stuff. Uh, so I think what I'm going to do is I'm going to use the same circuit for the outdoor lights, this hallway light, and then I'm going to give this circuit to my recess lights cuz it's low voltage. Keep that independent. and then put the second circuit in here for just the outlets down below, uh, including the TV. So, uh, going to get back up there, start running those lights, give it a second circuit. We should be good. [music]

Auto-generated from the video audio.