Reassemble Diffuser and Rear Handle

5:30

8:49

27.5K views

At 5:30 in

Repacking A Titan LX80 Airless Paint Gun. Airless Sprayer Hacks.

Watch on YouTube

What happens here

Take the diffuser, now loaded with the new washer and seat, and screw it back onto the front of the gun. Make sure it's threaded correctly and tighten it securely. Next, pick up the two previously cleaned guide rods and drop them back into their respective holes in the rear of the gun. Align the back handle assembly with the guide rods and the main body. Begin threading the new 3/8-inch nut (from the repair kit) onto the back of the gun. Once it's started, use a 3/8-inch socket or wrench to tighten it down until it's snug, but do not overtighten.

Goal: Screw the diffuser with the new components back onto the front of the gun. Then, reinsert the cleaned guide rods and screw the back handle assembly onto the gun, tightening it with a 3/8-inch socket.

Tools and materials

3/8-inch Socket/Wrench
Titan Repair Kit (584-045)

What they say

(896 characters)

Hide

And now it's ready to set. Going to take the diffuser, Now I'm going to take my new needle assembly and got it my hand. I'm just going to drop it down in the gun. And then I'm going to take get the back of my gun ready to assemble. I'm going to drop my two guide rods down in the gun. I'm going to get the back of the gun and it'll glide. It'll slide right on. It's got two flat sides of a screw. And you want to set your gun down on a soft surface, something that's not going to score the needle. You can take just like I could I use a rag or something soft. Set it down. And then you push your gun down and that'll pop that the end of the needle assembly up so you can begin screwing the bolt back on. And I'll get it started. here. Can take my 3/8 inch socket and begin screwing it back on. Once it's started, you don't have to push anymore. Now my bolt is started. Getting it screwed on here.

Auto-generated from the video audio.