Final Tightening and Function Check

7:26

8:49

27.5K views

At 7:26 in

Repacking A Titan LX80 Airless Paint Gun. Airless Sprayer Hacks.

Watch on YouTube

What happens here

To complete the assembly, ensure the needle is properly positioned. Gently push the gun down on a soft surface (like a rag) to slightly expose the tip of the needle. While the needle tip is exposed, pull and hold the trigger. This pulls the needle back. With the trigger held, use a crescent wrench to tighten the diffuser down completely. This ensures the new seat and washer are compressed correctly. Release the trigger. Test the trigger pull action. The goal is a smooth pull. If needed, you can make minor adjustments to the tightness of the rear nut to fine-tune the trigger's feel and ensure proper operation once connected to an airless sprayer.

Goal: Make final adjustments to the diffuser and back nut by following a specific tightening sequence, then test the trigger pull and make any necessary adjustments.

Tools and materials

Crescent Wrench
Rag/Soft Surface N/A

What they say

(1,029 characters)

Hide

through. Now I can pull my trigger. It's going to pull the needle back. Now I got my diffuser. I'm going to take my seat and the washer. And you can drop the seat and the washer down in there. And it's going to go flush. It's going to fall all the way down to the bottom. You're going to drop it down in there. And then you're going to screw that diffuser back on the gun. I'm going to pull my trigger down to keep the ball from scoring on the new seat. Going to tighten my diffuser down. Holding the trigger down the whole time. Once I got this diffuser screwed down and tight, I'm going to come back to my the back side of my needle assembly and just snug with my 3/8 in socket. Snug this down. and it'll screw all the way down to you'll feel it where it gets tight and snug. And now you got your full trigger pull. And then yeah, you hook your gun up and test it, make any adjustments to your trigger once it's up and running on your airless sprayer. This is Chris the Auto Painter. How to install a new packing kit in a Titan

Auto-generated from the video audio.