Skip to main content
Stesso

Spray Painting the Door

16:58
28:10
216K views

At 16:58 in

Professional Finish with Spray Cans?! How to Get Airless Sprayer Results from a Can!

Watch on YouTube

What happens here

Before starting to paint, the presenter puts on a respirator mask and gloves for safety, as oil-based paint requires proper ventilation and protection. He shakes the Rust-Oleum Turbo Spray System can thoroughly. He advises doing test runs on cardboard before spraying the actual door, but opts to spray directly for demonstration purposes. He applies three coats of white paint to the metal door, moving the can consistently to ensure even coverage. He mentions that the paint dries quickly, allowing for multiple coats in a short period. He notes that if paint is applied too closely, especially near edges, it can run, so maintaining a distance of about 12 inches from the surface is recommended. After three coats, he states that the door is tacked up and appears finished, and that he applied a final (fourth) coat as well.

Goal: Apply multiple even coats of paint to the door for a durable, professional finish.

Tools and materials

  • Cardboard — Performing test runs before painting the actual door
  • Gloves — Protecting hands from paint
  • Respirator Mask RZ Mask — Protecting respiratory system from paint fumes

What they say

Hide

you want to wear a mask here we go [Music] so now i've sprayed your three coats on this door we'll see it's already tacking up let's give it about 15 minutes and we'll pull the masking see how it looks so it's been about hasn't even been about 10 minutes and it's already tacking up pretty good down here our wind has died down too which is nice but man for a spray can that was fast and that's sprayed out uh like it like a sprayer like an airless spare i'd say your narrow sprayer is going to give you a little bit finer you know finish but man if you didn't have access to an airless sprayer you didn't have time to load up an airless sprayer and you just needed to use a spray can that's sprayed out pretty incredible i've got i just did like a first coat fog coat on there and um there was a little bit of fish iron on it and i could have stopped right there and tried priming over the fisheye is tacking up like really fast i sprayed a second coat and the fisheye uh was um didn't show up again so i wasn't uh concerned about wiping it down i wiped it down with the crud cutter but there was all obviously some type of contaminant on there that caused the fisheye but it looks pretty good um you know no um put it on there if you know light fog coat next coat was a little bit heavier uh next coat was um about the same as the second coat i'm gonna spray i think i'll probably spray one more coat on here and then that'll be good

Auto-generated from the video audio.