Smooth and Blend the Applied Texture

3:55

5:06

303.4K views

At 3:55 in

Patching a Hole in a Wall and Using Spray Texture. Tips Using Homax spray texture.

Watch on YouTube

What happens here

After the spray texture has dried for approximately 5 minutes (for oil-based products), inspect the applied texture. If there are any sharp points or areas that appear slightly too heavy, gently rub over them with a sanding sponge. Use very light pressure to just knock down the high spots, ensuring the texture remains subtle and blends smoothly with the surrounding wall. The goal is to make the texture appear flat and uniform with the rest of the wall.

Goal: Refine the texture for a seamless and natural blend

Tools and materials

Sanding Sponge — Lightly knocking down sharp texture points for a smoother finish

What they say

(923 characters)

Hide

sand it all off and redo it again. But that looks pretty good right there. And then if we'll let it dry about 5 minutes. And if the pattern on the wall looks like it's a little bit flatter, we just take a sanding sponge and we'll just rub the sanding sponge over it very, very lightly just to knock down any heavy little spots on it. And then it's ready to paint. And that's how you spray texture a wall, a patch in a wall. So, it's been about 5 minutes now. Our spray texture is dry. And we've just got a sanding sponge right here. And we're just going to There's just a few little um sharp points and stuff on that. So, we're just going to take our sanding sponge and just lightly rub it over it just to knock down any of the little heavy spots. And it looks flat. Looks like the texture on the wall, it's blended in, faded out nicely. So, you won't see um the patch very well at all. And now that I'm all done, I don't I

Auto-generated from the video audio.