Cut In Around Ceiling Fan Escutcheon Plate

1:48

6:35

111.3K views

At 1:48 in

Painting HIGH Ceilings. How to paint hard to reach areas. Painting with a brush holder.

Watch on YouTube

What happens here

Begin the 'cutting in' process around the ceiling fan's escutcheon plate. Dip the brush into your paint bucket (a 2-gallon cut-in bucket as shown, often with a screen to remove excess paint). Extend the pole to the desired length. Position the brush a few inches away from the fan plate on the ceiling, then slowly and steadily guide it towards the edge of the plate, creating a clean, straight line. Take your time and go slow, especially when working on textured ceilings to avoid paint bleeding under the brush or making jagged lines. The goal is to get within about an eighth of an inch of the plate, as minor imperfections will not be noticeable from the floor due to the height. Continuously adjust the angle of the brush holder and the position of the extension pole to comfortably reach all sides of the escutcheon plate.

Goal: Apply paint neatly along the edges of the ceiling fan base.

Tools and materials

1-gallon Bucket Screen Unspecified — Removing excess paint from the brush to prevent drips
2-gallon Cut-in Bucket Unspecified — Holding paint for easy access and mobility
2.5-inch Angled Sash Brush Unspecified — Applying paint with precision around edges
Brush Holder Unspecified — Holding the brush during cut-in
Extension Pole Pin Lock — Reaching high areas of the ceiling

What they say

(1,224 characters)

Hide

in with this thing. So, now we're just getting up on this 10ft ladder. Show you what it looks like here. Two roll the same. Just got a four to eight foot extension pole. Just take your time. Go slow. There's no hurry. You just don't want to touch the light. And all you got to do is just get like within an eighth of an inch cuz it's so high. Nobody can tell. Just make adjustments to your brush just to get around. Work around the area you need to work around. Just use your pole to just move around the fan. Did one of these a few days ago that was even higher. It's probably like even 5t higher. You can see just working really slow, cutting it in. Just got to take your time. Have a steady hand. Just working around the furniture. We thought we'd have to move the furniture and uncover it, but it's been working just fine. We're able to reach without it. So, it's a good idea to have this stuff covered just in case you drip any paint or drop your brush or if any accidents happen. See, now we're on the opposite side of the light. And now we'll start cutting around this side right here. So, you just set your brush few inches away from the plate and you kind of start slowly working to the plate. The scotch and plate.

Auto-generated from the video audio.