Skip to main content
Stesso

Demold and Finalize Splice

0:38
1:01
9.1K views

At 0:38 in

Made Your Own Weatherproof Electrical Connections! #diy #electrical #automobile #tools

Watch on YouTube

What happens here

Allow the injected sealant to cool and solidify within the mold for about 30 seconds. Once cooled, unclamp the mold and carefully separate its halves to reveal the fully encapsulated wire splice. The splice will now be encased in a solid, waterproof block of sealant. Twist or snap off any excess plastic or sealant material that may have formed around the edges of the mold, leaving a clean and finished splice. The connection is now waterproof and ready for service.

Goal: After the sealant has cooled and solidified, remove the encapsulated splice from the mold and clean off any excess material.

What they say

Hide

that it is centered. Clamp the mold, >> inject it with a hot sealant. >> 30 seconds later, you remove it from the mold and you have what looks like that. You twist or snip the sprew off and you're good to go. >> Awesome, dude. >> Less than a minute, you're back in service. >> We got a watertight seal that's going to last you forever at this point. All right. Where can we find this at?

Auto-generated from the video audio.